I am not sure if it is mounted but I am getting somewhere, not there yet but I'm a little bit ahead of where I was when I started this post. How do I remove that from the 'burn' area and put the smaller flle (SI) into the burn area?

After the VHS movie finished, and was captured by this program, I had not editing to do so I went to 'burn', it only wants to recognize a previous project (STN), which is too big to burn to a DVD. Earlier today I captured a VHS tape called STN, I forgot to change those setting so that file is 6.6GB and I will have to figure out a way to compress it since then I captured the one that is fine, that one is called SI, I saved it, I have a file in a folder on that machine which is a mpeg-2 video called SI, and small enough to burn to a SL DVD. The last VHS tape that I captured is fine, I remembered to change the quality settings to a low enough bit rate that the file will fit on a DVD, bu the 'burn' section of the program will not let me use that file. It came with basic honestech capture and burn software, the first time I tried using it I figured out that I might have to change the quality setting (bitrate) in the capture settings, I got that one VHS burned to a DVD, the next several times I captured a VHS tape I forgot to do so, so now I have a bunch of mpeg-2 movies that are too big to burn to a DVD does this software compress video? I'm pretty sure not, and I will have to use something else to make those files small enough to fit on a standard, single laver, 4.7GB DVD. I am trying to use this USB video capture device to digitize VHS tapes, it is not too difficult to get an mpeg-2 file onto a hard drive connected to a Win 7 machine, but it has mostly been a nightmare after that. Does anyone monitor (and bother to try to answer) these posts? I was the last person to post something here, weeks ago (no replies).

Unistalling igrabber on mac